Vacuum Pump In-Line Air Purifiers
Prevents Pollution of Work Environments
Minimal H2O Pressure Drop
Made with Adsorbent Activated Carbon
Particle Filtration to 0.5 Microns
Vacuum Pump In-Line Air Purifiers, Models VP-100, VP-200, VP-300, VP-400,
are specifically designed to remove harmful organic vapors, aerosols,
fine particles, and other foreign matter from vacuum air and compressed
air. Units prevent pollution of laboratory and industrial work environments.
Models 250-JCB, 500-SKB, MF-4SKCB, Vacuum Pump In-line Air Purifiers
are recommended for installation after mercury filled manometers, instruments
and other calibration equipment. Unlike VP Series Purifiers, units are
supplied with impregnated carbon for efficient adsorption of hazardous
mercury vapor not readily removed by standard activated carbon.
here for a general list of contaminants removed by this filter.
25-JCB, 500-SKCB, MF-2JKCB, MF-4SKCB are manufactured with a high grade
impregnated carbon specifically used for mercury adsorption. Each gram
of carbon can adsorb approximately 5% of its own weight in mercury vapor.
For best results, install purifier on discharge side of vacuum pump.
Monitor mercury levels routinely on purifier outlet to insure effectiveness,
and replace when mercury levels exceed permissible exposure levels.
When removing heavy concentrations of mercury over 1500 ug/m3,
it is advisable to install purifiers in series as shown below for added
can be easily installed directly to vacuum pump, or system piping using
standard NPT pipe fittings. Replace according to specified manufacturer's
replacement, or when a noticeable odor is detected on purifier discharge.
When used only to remove fine particles, replace every six months from
date of installation.
on Model number for complete specifications.